Of course, when we use CNC machine tools daily, we must not forget to maintain the machine tools. A small maintenance can bring better working conditions.

1. CNC machine tool brand operators are responsible for the use of equipment, CNC machine tool maintenance and basic maintenance;

2. The equipment maintenance personnel of CNC machine tool company are responsible for the repair and necessary maintenance of the equipment;

3. The workshop management personnel are responsible for the supervision of the operators and equipment maintenance of the entire workshop.

Basic requirements for the use of CNC equipment

1. Numerical control equipment requires to avoid places with dampness, excessive dust and corrosive gas;

2. Avoid direct sunlight and other heat radiation, and keep precision CNC equipment away from equipment with large vibrations, such as punches, forging equipment, etc.;

3. The operating temperature of the equipment should be controlled between 15 degrees and 35 degrees. The precision processing temperature of CNC machine tools should be controlled at about 20 degrees, and temperature fluctuations should be strictly controlled;

4. In order to avoid the influence of large power fluctuations (greater than plus or minus 10%) and possible instantaneous interference signals, the numerical control equipment-generally adopts dedicated line power supply (for example, it is divided from the low-voltage power distribution room to a separate channel for use by the numerical control machine tool), and a voltage stabilizer is added Devices, etc., can reduce the impact of power supply quality and electrical interference.

Daily processing CNC machine tool processing and maintenance methods precision maintenance

1. After starting up, it must be preheated for about 10 minutes before processing; the machine that is not used for a long time should extend the preheating time;

2. Check whether the oil circuit is unblocked;

3. Put the workbench and saddle at the machine position before shutting down (move the three-axis stroke to the middle position of each axis stroke);